Komatsu PC210LC-11 Operation & Maintenance Manual page 213

With continuous camera view
Hide thumbs Also See for PC210LC-11:
Table of Contents

Advertisement

OPERATION
Never disassemble, repair, modify, or move the communications terminal, antenna, or cables. This
may cause failure or fire on the KOMTRAX equipment or the machine itself. (Your Komatsu distribu-
tor will perform removal and installation of KOMTRAX.)
For anyone wearing a pacemaker, make sure that the communications antenna is at least 22 cm
from the pacemaker. The radio waves may have an adverse effect on the operation of the pacemak-
er.
Near the blasting jobsite, there may be a danger of unexpected explosion due to use of interactive
wireless communication device of KOMTRAX and resulting serious personal injury or death. Make
sure to operate the machine away from the blasting jobsite.
If you have to operate the machine within 12 m from the blasting jobsite or the remote-controlled
blasting device, the power supply cable of KOMTRAX must be disconnected in advance. If you want
to do this, ask your Komatsu distributor for disconnecting power supply cable of KOMTRAX.
Also, if there are any requirements or regulations of the territory or country where the machine
equipped with this device is used, such requirements or regulations have a priority than this warn-
ing.
When checking for compliance with regulations, refer to the following KOMTRAX equipment satel-
lite communication specifications.
Rated transmit power: 5 to 10 W
Transmit frequency:148 to 150 MHz
PRECAUTIONS FOR USING KOMTRAX
Even when the key in the starting switch of the KOMTRAX system is at OFF position, a small amount of
electric power is consumed.
When using the battery disconnect switch, turn the starting switch to OFF position and turn the battery dis-
connect switch key to OFF position. Then, remove the key.
When the battery disconnect switch is turned to OFF position, it is possible to prevent power consumption
of the battery, but the functions of KOMTRAX stop at the same time.
Contact your Komatsu distributor before installing a top guard or other attachment that covers the cab roof.
REMARK
The KOMTRAX device uses wireless communications, so it cannot be used inside tunnels, underground, inside
buildings, or in mountain areas where radio waves cannot be received. Even when the machine is outside, it
cannot be used in areas where the radio signal is weak or in areas outside the wireless communication service
area.
OBSERVANCE OF THE APPLICABLE LAWS AND REGULATIONS, EXEMPTION
The KOMTRAX equipment is a wireless device using radio waves, so it is necessary to obtain authorization and
conform to the laws of the country or territory where the machine equipped with KOMTRAX is being used. Ob-
serve the applicable laws and regulations of the country or region in which the machine is used.
Always contact your Komatsu distributor before exporting this machine equipped with KOMTRAX or using it in a
foreign country.
The KOMTRAX may already have been registered and used if the machine is purchased as second-hand. For
the registration and usage records of KOMTRAX, consult your Komatsu distributor.
If the machine has been lent out by the customer, the borrower or another third party may have been using the
KOMTRAX. Confirm with the lessor about using condition of KOMTRAX.
Komatsu may suspend KOMTRAX communication in the following cases.
When Komatsu judges that KOMTRAX is used by an unregistered customer.
When Komatsu judges that KOMTRAX is used in a country or region where its use is not authorized.
In other cases that Komatsu or Komatsu distributor judges that it is necessary to suspend KOMTRAX com-
munication.
k
k
WARNING
EXPLANATION OF COMPONENTS
3-139

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pc210-11Pc210nlc-11Pc230nhd-11

Table of Contents