Table of Contents
Advertisement
EXPLANATION OF COMPONENTS
REMARK
•
Spare fuses are installed in the back of the fuse holder lid
at the rear right of the operator's seat.
•
After using spare fuses, replenish them immediately.
•
One spare fuse is installed for each 5 A, 10 A, 20 A, 25 A,
and 30 A.
FUSIBLE LINK
NOTICE
Before replacing a fusible link, be sure to turn the starting switch to OFF position and check that the
system operating lamp is off., then turn the battery disconnect switch key to OFF position.
If the engine starting motor does not operate even when the
engine starting switch key is turned to START position, fusible
link (1) (2 places) may be broken. Open the cover on the left
side of the machine to check the fusible links, and replace
them.
REMARK
A fusible link refers to the large-sized fuse wiring installed in
the high current flow portion of the circuit. It protects electrical
components and wiring from burning, in the same way as an
ordinary fuse.
TOOL BOX
Store the tools in it.
This is installed in the tool case at the right of the machine.
GREASE PUMP HOLDER
This is installed in the tool case at front right of the machine.
Keep the grease pump hooked on this holder while it is not
used.
FIRE EXTINGUISHER
(if equipped)
3-110
OPERATION
Advertisement
Table of Contents
