Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
Adjust mirror (1).
Tightening torque of mounting bolt (2): 6.0 to 7.0 Nm {0.61 to
0.71 kgm}
Mounting position (3): 275 mm
Mounting position (4): 25 mm
Mounting angle (5): 60 °
Mounting angle (6): 75 °
Tightening torque of mounting bolt (7): 6.0 to 7.0 Nm {0.61 to
0.71 kgm}
NOTICE
•
Tighten the right and left bolts of each bracket alter-
nately so that their right and left clearances (R) and (L)
become equal.
•
If the mirror and stay mounting bolts are tightened ex-
cessively, the bracket may be damaged. Be sure to
tighten bolts to the specified torque.
Adjust the mirror so that the side of the machine is reflected in
the mirror as shown in the figure.
PROCEDURE FOR ADJUSTING MACHINE RIGHT SIDE MIRROR (C)
To prevent the machine from moving during the work, make sure that the following conditions are met
before starting the work.
•
The machine is placed on a firm, level ground.
•
The work equipment is lowered to the ground in secure posture.
•
The lock lever is in LOCK position.
•
The engine is stopped.
3-168
k
k
CAUTION
OPERATION
KS001177
KS001178
Advertisement
Table of Contents
