OPERATION
2.
On the standard screen, auto-deceleration pilot lamp lights
up.
(When the auto-deceleration is OFF, the indication lamp
goes out.)
TRAVEL SPEED SELECTOR SWITCH
•
When loading to or unloading from a trailer, always drive the machine at low speed (set the travel
speed selector switch to Lo) and never operate the travel speed selector switch during travel.
•
If the travel speed is when the machine is traveling, the machine may deviate to one side, even
when traveling in a straight line. Stop the machine before switching the travel speed. Stop the ma-
chine before switching the travel speed.
Travel speed selector switch is used to select the travel speed
from 3 stages.
Lo lights up: Low-speed travel
Mi lights up: Mid-range speed travel
Hi lights up: High-speed travel
When the engine is started, the speed is automatically set to
Lo.
Each time that the switch is pressed, the display changes Lo →
Mi → Hi → Lo in turn.
Even if the travel speed is set to high-speed (Hi) or a mid-range
speed (Mi), when traveling on soft ground or uphill, and travel
power is needed, the system automatically shifts down to low-
speed travel (Lo). There is no need to operate the switch. In
this case, the travel speed on the monitor display stays lit at Hi
(high-speed) or Mi (mid-range speed).
k
k
WARNING
EXPLANATION OF COMPONENTS
3-47