adept technology SmartController EX User Manual page 20

Removing an SD Card
To remove an SD card from a Adept SmartController EX motion controller:
1. Make sure that the controller is disconnected from its power source.
2. Locate the SD compartment (see the following figure).
SD Card Slot
NOTE: If you are replacing an existing SD, the original must be sent to Adept for replacement.
3. Press the SD card in, and release. The card will pop out.
Remove the card and return it to Adept. Contact Adept Customer Service.
Installing an SD Card
To install an SD card into a Adept SmartController EX motion controller:
1. Make sure that the controller is powered off.
2. Locate the SD card compartment (see the preceding figure).
3. Carefully remove the SD card from the READ ME FIRST box or shipping container.
Position the card so its contacts are facing towards the controller and to the left. The
label will be facing to the right.
4. Insert the SD card into the controller.
Once installed, Adept recommends that you do not repeatedly remove and insert the SD card.
Adept SmartController EX User's Guide, Rev.C
Chapter 2: Installation
CAUTION: Do not remove the SD card when power is connected to the
controller.
Figure 2-5. SD Memory Card Compartment
Page 20 of 96