Table of Contents
Advertisement
Panel-Mounting the sDIO Module
To panel-mount the sDIO module, install one bracket on each side of the back of the unit, as
shown in the following figure. Use the screws from the accessories kit.
186.5
14.0
27.6
4X M3 x 6 MM
10.0
16.0
6.6
Table-Mounting the sDIO Module
To table-mount the sDIO module, install two brackets on each side near the bottom of the unit,
as shown in the following figure.
NOTE: These brackets must be ordered separately. They do not come with the sDIO module.
Adept SmartController EX User's Guide, Rev.C
Chapter 6: sDIO Module
273.9
346.4
359.6
Figure 6-3. Panel-Mounting the sDIO Module
Page 63 of 96
2X 40356-00000
18.0
R 3.6
Advertisement
Table of Contents
