Table-Mounting the Adept SmartController EX Motion Controller
To table-mount the controller, install two brackets on each side near the bottom of the unit, as
shown in the following figure. These brackets must be ordered separately. They do not come
with the controller.
4X 40356-00001
29.5
120.9
24.9
Figure 2-3. Table-Mounting the Adept SmartController EX Motion Controller
Stack-Mounting Components
To stack-mount the Adept SmartController EX Motion Controller and a compatible unit, such
as an Adept SmartVision EX vision controller, install two brackets on each side of the units, as
shown in the following figure. These brackets are supplied with compatible Adept units.
Adept SmartController EX User's Guide, Rev.C
Chapter 2: Installation
R3.6
378.6
391.8
Page 18 of 96
12.1
24.1
4X M3 x 6MM
BOTH SIDES
16.2
120.9
16.0
21.6