Assembly Of Connector - Omron V720S Series Operation Manual

Wiring Method

4-4-3-2 Assembly of Connector

Insert assembly
Reader/Writer power connector
リーダライタ電源コネクタ
4-16
1) Strip a part of the envelopes of the cable terminal and the conductors
according to the measurements specified in Tables A and B.
Conductor envelope
2) Insert the fastening nut, washer, gasket, washer, rear shell, and con-
necting ring (this is not necessary if a jack is used) in this order at any
desired part of the cable.
3) Solder the conductors to the contact.
Insulating tube
Note • After the soldering process, remove paste, dirt and any other foreign
matter from the insulation surface.
• Protect the soldered part with an insulating tube or the like.
4) Secure the insert assembly (plug and jack) to the dummy receptacle and
fasten the rear shell to the fastening torque specified in C, Table 1.
Use the power connector of the Reader/Writer to serve as a dummy re-
ceptacle for wire bound.
Connecting ring
Cable
Soldering
Connection ring
Envelope
Rear shell
Gasket
Washer
Washer
Rear shell
Section 4-4
Fastening nut