Read And Write Of Family Code (For Reader/Writer) (Fc): I.code1 Mode Only - Omron V720S Series Operation Manual

Setting Command
5-6-3 Read and Write of Family Code (for Reader/Writer) (FC): I.CODE1
Mode Only
The FC Command is used to set or read the Family Code in the Reader/Writer. Only Tags that have
the same Family Code as the one set by this command can perform communications. If this Family
Code is set to 00, communications will be possible with all Tags. The default set value of the
Reader/Writer is 00.
<Command Format>
Node No.. Command code
STX
1 2
Family Code
<Response Format>
STX Node No..
1 2
Response code
Family Code
5-38
Family Code ETX BCC
"FC"
2 2
The Family Code is designated in hexadecimal.
Specification range: 00h to FFh (factory setting: "00"）
When the Family Code set to "
Reader/Writer will be read.
Response
Retry Command code
flag "FC" code
"00"
1 2 2
00:normal completion
For other response codes, refer to 5-2-4 Response code List.
Indicates current Family Code in hexadecimal.
Note • A setting becomes valid after executing Reset Command. To keep the
setting valid next startup, you need to save with Setting Write Command
(refer to 5-6-14 EW Command).
• This command is for I.CODE1 Mode Only. The command is not available
in ISO mode.
1 1
," the Family Code currently set in the
Family Code ETX BCC
2 1 1
Section 5-6