Node Number Setting Command (Nn) - Omron V720S Series Operation Manual

Setting Command

5-6-6 Node Number Setting Command (NN)

This command sets and reads the node number of the Amp-Reader/Writer.
<Command Format>
STX Node No.
1 2
Node number
change specifica-
tion
<Response Format>
STX Node No.
1 2
Response code
Node number
Command Node number
code change speci-
"NN" fication
2 2
Specifies the node number in decimal that you want to change.
Specification range: 00 to 31, *
When * is specified, the Reader/Writer reads the current setting.
Retry Command Response
flag code code
"NN" "00"
1 2 2
00: Normal completion
For other response codes, refer to 5-10 Response Code List.
Indicates the specified node number in decimal.
Note • The setting becomes effective after resetting using the Reset Command.
• In order to make your setting survive system shutdown, you need to save
the Setting Write Command (refer to EW Command in 10, 5-2-4) in the
EEPROM.
ETX BCC
1 1
Node number ETX BCC
2 1
Section 5-6
1
5-41