Table of Contents
Advertisement
EAS Function
3-7
EAS Function
3-8
This Reader/Writer supports EAS function of applications such as
theft-prevention devices.
This function supports the online mode to be executed by the commands
from the host, and the offline mode to be executed only by Reader/Writer
(See 3-6 "Offline Test Function").
(1) For Tag EAS bit setting, execute System Write (SW) (see 5-4-2) for
ISO/IEC chip (I.CODE2 chip), and execute EAS Setting command (ES)
(see 5-4-7) for I.CODE1 chip.
(2) Reader/Writer setting
To make this setting, execute Offline Mode Setting command (FL)"
described in 5-6-12.
* The setting of the online and offline mode
* The criterion setting after reading the EAS code from Tag
A Tag returns 256-bit fixed data. When there are the certain
coincidences on a percentage basis, Reader/Writer sets whether or
not to detect EAS bit as un-negated (EAS bit disabled processing)
Tag. The smaller the value is, less severe the criterion is. The initial
value is 25%.
* When Reader/Writer setting judges EAS bit un-negated in the
offline mode, Reader/Writer sets ON time of External Output 1
(OUT1) which is to be connected to a lump and a buzzer, etc.
The initial value of output time is 500 ms.
(3) EAS Check
In the online mode, execute EAS Check command (EA) described in
5-4-12.
Section 3-7
Advertisement
Table of Contents
