Response Command List - Omron V720S Series Operation Manual

Command and Response Frame Structures

5-2-4 Response Command List

Response codes in response frames are shown below.
Response
Type
Code
Normal "00"
completion
"72"
"74"
"75"
"76"
Host commu- "10"
nications error
"11"
"12"
"13"
"14"
"18"
Communica- "70"
tions error
"71"
"72"
"79"
System error "93"
Warning "01"
"02"
"03"
"04"
"05"
"06"
"07"
Name
Normal completion
Multi-processing end
Selective detection completion
Polling command received
Polling processing canceled
Data normal
Polling processing canceled
Data error
Parity error
Framing error
Overrun error
BCC error
Format error
Frame length error
Communications error
Write process error
No Tag error
Command error
Memory error
Specified No. of Tags exceeded More Tags than have been specified in the Tag No. setting have entered
Specified No. of retries ex-
ceeded
No. of Tags exceeded
No. of retries exceeded
Communications error
Specified No. of Tags exceeded
Communications error
No. of Tags exceeded
Communications error
No. of Tags exceeded
No. of retries exceeded
Communications error
Note The warning codes are used in a response code that is generated during the
multi-read process, in order to return read data in a Tag when a communica-
tions error occurs.
The received command ends normally with no error.
Communications end response when a multi-trigger function is used.
Communications end response when a selective access/detection func-
tion is used.
Polling command has been received normally.
Polling Check is received before the completion of communications with
a Tag.
Polling processing is canceled before the completion of communications
with an ID Tag.
Results of the memory calculation command (MK) check code verifica-
tion are normal.
Polling processing is canceled after the start of communications with an
ID Tag.
Results of the memory calculation command (MK) check code verifica-
tion show an error.
A parity error occurs in one of the characters of the received command.
A framing error occurs in one of the characters of the received com-
mand.
An overrun error occurs in one of the characters of the received com-
mand.
The received command has an incorrect BCC.
The command format is incorrect.
A stop command is received in command-waiting status.
In Selective Access mode;
1) A temporary number not saved using the Tag detection command is
specified.
2) A tag detection command normal end is retried after it has been sent.
ETX is not received in 151 characters or less after STX is received.
An error occurs during the communications with an ID Tag, and commu-
nications cannot end normally.
Tag is in an area that can be read, but not written to.
You are trying to write to a locked page (i.e., write-protected).
The correct data cannot be written to the Tag.
Verify read results in an error.
No Tag is present in front of Antenna when a Trigger command is exe-
cuted.
There are multiple Tags within the communications area when using
Single Access mode.
Refer to the correlation table of ISO/IEC Error Codes.
An error has occurred in the Reader/Writer memory.
the communications area.
Tag detection has been retried the specified number of times to find all
the Tags in the communications area, but some Tags have not been
detected.
Two of the warning, "01" and "02," have occurred.
An error occurs during communicating with Tags, resulting in successful
communications with only some of the Tags.
Two of the warnings, "01" and "04," have occurred.
Two of the warnings, "02" and "04," have occurred.
All the three warnings, "01," "02," and "04," have occurred.
Section 5-2
Description
5-7