Table of Contents
Advertisement
Reader/Writer Setting
4-1-5 Offline Mode Setting
4-1-6 Fixing of Settings
4-1-7 Initialization of settings
Set whether the Reader/Writer will start in offline mode or online mode.
If you choose offline mode, the Reader/Writer will perform EAS check inde-
pendent of the host.
This setting can be made by using the offline mode setting command (FL)
(refer to No. 8 in 5-6-12 of Section 5).
Setting name
(command name)
Offline Mode Setting
(FL command)
Note The default mode is offline mode. You can exit offline mode by connecting to
the host and sending a Stop Command (ST) (refer to 1), 5-5-1, Section 5). If
you want to start the product with online mode the next time, first disable off-
line mode as stated above and then fix this setting (4-1-6, Section 4).
By fixing the settings that you have made using various setting commands,
you can write them into the EEPROM (nonvolatile memory) so that they will
survive a power reset of the Reader/Writer.
Use the EEPROM write command (EW) to fix your settings (refer to No. 10 in
5-6-14 of Section 5).
Setting name
(command name)
EEPROM write
(EW command)
Note • Settings are only saved in the S-RAM (volatile memory) in the
Reader/Writer. Unless you fix your settings with this command, they will
return to the initial values on a power reset.
• This command does not work on communications settings for COM2.
• Depending on setting items, a power reset of the Reader/Writer will be
required for settings to be effective.
If necessary, you can return all the settings to their default set values.
Use the initialize settings command (IS) to return your settings to their default
set values (refer to No. 9 in 5-6-13 of Section 5).
Setting name
(command name)
Initialize settings
(IS command)
Default set value
Enable (offline mode)
Section 4-1
Setting range
Enable/Disable
4-5
Advertisement
Table of Contents
