Omron V720S Series Operation Manual page 54

Wiring Method
! Caution
5) Soldering
Iron tip
Wire
Contact
6) Reassemble the connector as follows.
Screw the barrel into the end bell and secure it with Set Screw A.
Push the cable packing and washer into the end bell, secure the end bell,
and screw the clamp nut in.
After swinging the cable in various directions to settle the parts on the
cable (Fig. 1), re-tighten them to the specified torques and secure them
with Set Screw B.
Cable packing
Clamp nut
Set screw B
Washer
(Fig. 1)
Fig.1
Model name of connector plug for host communications: NJW-165-PM7
from Nanaboshi Electric Mfg. Co., Ltd.
Model name of I/O connector plug: NJW-2010-PM10 from Nanaboshi
Electric Mfg. Co., Ltd.
Waterproofing effects vary depending on the finish of the cable envelopes
and the condition of the materials inside the cable. Before use, be sure to
check for the proper torques and the waterproof effects of the cable of your
choice. OMRON does not offer any guarantee for customer-made cables.
Please inquire to the manufacturer for details of these connectors.
(1) Insert the pre-soldered wire into the solder
pot of the contact.
(2) Heat the contact and the conductors with a
soldering iron.
Solder
(3) Pour solder to fill the opening between the
contact and the conductors.
Soldering iron to use
30W
Coupling nut
End bell
Set screw A
• Tightening torque for screws
End bell
Clamp nut
Set Screws A and B
Section 4-4
Conductor cross-sectional area
2
(mm )
0.5
Cable
0.010 - 0.015
0.015 - 0.020
0.002 - 0.003
Barrel
Unit:N m
•
4-15