Eas Setting (Es): I.code1 Mode Only; Quietbit Setting (Qb): I.code1 Mode Only - Omron V720S Series Operation Manual

System Command

5-4-7 EAS Setting (ES): I.CODE1 Mode Only

This command sets the EASBit of a Tag incorporating I.CODE1 chip. When the EASBit is disabled,
the Reader/Writer will not return a response to the EAS Check Command (EA).
<Command Format>
Node No.. Command code
STX
1 2
<Response Format>
STX Node No..
1 2
Response code

5-4-8 QuietBit Setting (QB): I.CODE1 Mode Only

This command sets QuietBit of a Tag incorporating I.CODE1 chip. If you enable this bit, a Tag
ceases to return a response to any command (excluding the EAS Command).
<Command Format>
Node No.. Command code
STX
1 2
Setting
<Response Format>
STX Node No..
1 2
Response code
Setting
00to01
"ES"
00:EAS en-
abled
01:EASdisable
d
2 2
Retry Command code Response
flag "ES" code
"00"
1 2 2
00:normal completion
For other response codes, refer to 5-2-4 Response Code List.
Note The relative commands are set in offline mode (refer to 5-6-12 FL Command).
This command is for I.CODE1 mode Only. The command is not available in
ISO mode.
Setting ETX BCC
"QB"
2 2
Specification range:00h to 01h
00: Disable QuietBit
01: Enable QuietBit
Retry Command code Response
"QB" code
flag
"00"
1 2 2
00:normal completion
For other response codes, refer to 5-2-4 Response code List.
Note This command is for I.CODE1 Mode Only. The command is not available in
ISO mode.
ETX BCC
1 1
ETX BCC
1 1
1 1
ETX BCC
1 1
Section 5-4
5-27