Wan Service Configuration; Figure 40. Wan Services Configuration Screen - ADTRAN 400 Series Basic Configuration Manual

3.14.1

WAN Service Configuration

The WAN Service Configuration screen is used to configure the WAN connection types.
g
NOTE
Entries in this menu are all Default values. The values in your system may be different. If they
are, complete the following steps to establish PPPoE.
1. In
2. In the
3. In the
4. In the
5. In the
6. In the
7. Select Next.
Device Info
Advanced Setup
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 40. WAN Services Configuration Screen

61287RGONT-29C
Revision C
Select WAN service type
Enter Service Description
is used. This indicates PPPoE is being established veip0.
pppoe_veip0
Enter 802.1P Priority (0-7)
example, 7 is used.
Enter 802.1Q VLAN ID (0-4094)
this service. For this example, 10 is used.
field, set the value to
VLAN TPID
Internet Protocol Selection
This displays
PPP User name and Password
WAN Service Configuration
Select WAN service tyoe::
Layer2 Interface
PPP over Ethernet (PPPoE)
WAN Service
IP over Ethernet
LAN
Bridging
MoCA
NAT
Security
Parental Control
Enter Service Description:
Quality of Service
For tagged service, enter valid 802.1.P Priority and 802.1Q VLAN ID.
Routing
For untagged service, set -1 to both 802.1P Priority and 802.1Q VLAN ID.
DNS
Enter 802.1P Priority (0-7):
UPnP
FTP Enter 8021.Q VLAN ID [0-4094]:
SIP ALG
Select VLAN TPID:
CloudAgent
DNS Proxy
Internet Protocol Selection:
Storage Service
IPV4 Only
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
field, select
PPP over Ethernet (PPPoE)
field, enter a description for this service. In the example,
field, enter the priority you want for this service. For this
field, enter the VLAN ID that will be associated with
Select a TPID
field, select
IPV4 Only.
screen (see
pppoe_veip0
v
Back Next
Basic Configuration
.
. for this example, 0x8100 is used.
Figure 41 on page 68).
7
10
0x8100 v
67