Step 3: Configure Data Service; Setup Wan Data Service; Figure 9. Wide Area Network (Wan) Service Setup Screen - ADTRAN 400 Series Basic Configuration Manual

3.9

Step 3: Configure Data Service

To configure data service, you must establish (add) a Wide Area Network (WAN) interface (this establishes the WAN
connection that the OLT in the Central Office uses to connect to the ONT in the field).
3.9.1

Setup WAN Data Service

Follow the steps below to add a WAN interface for data.
1. Select
Advanced Setup
2. Then select
WAN Services.
Device Info
Advanced Setup
Layer2 Interface
GPON Interface
WAN Services
LAN
NAT
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 9. Wide Area Network (WAN) Service Setup Screen

from the sidebar.
The Wide Area Network (WAN) Service Setup screen (see
Choose Add, or Remove to configure a WAN service over a selected interface.
Interface Description Type Vlan8021p VlanMuxId
veip0.1 ipoe_veip0 IPoE N/A N/A
veip0.2 br_veip0.1000 BRidge 3 1000
veip0.3 ipoe_veip0.100 IPoE 0 100
veip0.4 br_veip0.2000 BRidge 5 2000
GPON WAN Interface Configuration
VlanTpid Igmp Proxy Igmp Source NAT Firewall
N/A Disabled Disabled Enabled Enabled Disabled
0x8100 Disabled Enabled Disabled Enabled Disabled
0x8100 Disabled Disabled Enabled Disabled Disabled
0x8100 Disabled Disabled Disabled Disabled Disabled
Add Remove
Figure 9) is displayed.
IPv6 Mld Proxy Mld Source Remove Edit
Disabled Disabled
Edit
Disabled Disabled
Edit
Disabled Disabled
Edit
Disabled Disabled
Edit