Dns Server Configuration; Figure 15. Dns Server Configuration - ADTRAN 400 Series Basic Configuration Manual

Basic Configuration
3.9.6

DNS Server Configuration

Use the DNS Server Configuration screen selects the DNS server used as an interface for the
OLT that the system will use to communicate between the OLT and ONT.
Device Info
Advanced Setup
Layer2 Interface
WAN Service
LAN
NAT
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 15. DNS Server Configuration

g
NOTE
The values in the two windows above are for example purposes only. These values are estab-
lished by your Central Office and may be different for your system.
1. From the
g
NOTE
If a Static DNS IP address is required, enter it in the
2. Select
40
DNS Server Configuration
Select DNS server Interface from available WAN interfaces OR enter static DNS server IP addresses for the system.
In ATM mode, if only PVC with IPoA or static IPoE protocol is configured, Static DNS server IP addresses must be entered.
DNS Server Interfaces can have multiple WAN interfaces served as system dns servers but only one will be used according
to the priority with the first beign the highest and the last one the lowest priority if the WAN interface is connected.
Priority order can be changed by removing all and adding them back in again.
Select DNS Server Interface from available WAN interfaces:
Selected DNS Server Interfaces
veip0.3
Use the following Static DNS IP address:
Primary DNS server:
Secondary DNS server:
Available WAN Interfaces
move it to the
Selected DNS Server Interfaces
.
Next
This displays the WAN Status Summary screen (see
Summary" on page 41).
Available WAN Interfaces
veip0.1
->
<-
Back Next
window, select the DNS Interface that will be used and
window. For the example, veipo.1 is used.
Primary DNS server
Section 3.9.7, "WAN Setup
window.
61287RGONT-29C
Revision C