Figure 37. Configure Moca Interface Grouping - ADTRAN 400 Series Basic Configuration Manual

Basic Configuration
Device Info
Advanced Setup
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 37. Configure MoCA Interface Grouping

2. In the
3. The WAN Interface used in the grouping checkbox is checked by default. For this
4. Select the interface to be grouped from the Available LAN Interfaces list, then click on the
5. To automatically add clients, enter the DHCP Vendor ID string of the client in the
6. Select Apply/Save.
64
Interface Grouping Configuration
To create a new interface group:
Layer2 Interface
1. Enter the Group name and the group name must be unique and select either 2. (dynamic) or
3. (static) below:
WAN Service
2. If you like to automatically add LAN clients to a WAN Interface in the new group add the
LAN
DHCP client request with the specified vendor ID (DHCP option 60) will be denied an IP
address from the local DHCP server.
NAT
Security
3. Select interfaces from the available interfaces list and add it to the grouped interfaces list
using the arrow buttons to create the required mapping of the ports. Note that these clients
Parental Control
may obtain public IP addresses.
Quality of Service
4. Click Apply/Save button to make the changes effective immediately.
Routing
DNS IMPORTANT If the vendor ID is configured for a specific client device, please REBOOT the
device attached to the modem to allow it to obtain an appropriate IP address.
UPnP
Group Name:
FTP
SIP ALG
WAN Interface used in the grouping
CloudAgent
DNS Proxy
Grouped LAN Interfaces
Storage Service
wl0_GuestG|wl0.1
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Automatically Add Clients with the
following DHCP Vendor IDs
MoCA DHCP 11
field, enter a user-defined description for the Interface Group. For this
Group Name
example "MoCA" is used.
example, ipoe_veip0/veip0.1 is used.
arrow. The select interface is transferred to the Grouped Lan Interfaces window. In this
example, w10_GuestGw0.1 is used.
Automatically Add Clients With the following DHCP Vendor IDs. In this example,
MoCA DHCP 1 is used.
This displays the group you just configured (see
MoCA
ipoe_veip0/veip0.1
Available LAN interfaces
eth2.0
eth3.0
wlan0
wl0_GuestG|wl0.2
wl0_GuestG|wl0.3
->
wlan1
wl0_GuestG|wl1.1
<-
Figure 38
Apply/Save
on page 65).
61287RGONT-29C
Revision C