Removing A Video Interface Group; Figure 32. Remove Wireless Interface Group - ADTRAN 400 Series Basic Configuration Manual

Basic Configuration
3.11.6

Removing a Video Interface Group

To remove the video interface group, complete the following steps:
1. Refer to
2. Select
This removes the Interface Group and returns the Interface Grouping screen (see
Device Info
Advanced Setup
Layer2 Interface
WAN Service
LAN
NAT
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 32. Remove Wireless Interface Group

58
Figure 31 and place a check mark in the
Interface Group video.
Remove.
Interface Grouping -- A maximum 16 entries can be configured
Interface Grouping supports multiple ports to WAN interfaces and bridging groups. Each group will perform as an
independant network. To support this feature, you must create mapping groups with appropriate LAN and WAN interfaces
using Add button. The Remove button will remove the grouping and add the ungroupedinterfaces tot he Default group.
Only the default group has IP interface
Default
Default_Video
Add
Group Name Remove WAN Interface
veip0.3
veip0.4
veip0.2
Remove
column adjacent to the
Remove
LAN Interface DHCP Vendor IDs
wlan0
wlan1
eth2.0
eth3.0
wl1_GuestG|wl1.1
eth0.0
AMINO*
ENTONE*
Entone*
udhcp_*(ADB)
minerva*
DPC5003
DC1747TLV3
61287RGONT-29C
Figure 32).
Revision C