Removing Settings; Remove Wan Interface Setting; Figure 44. Remove Wan Interface Setting - ADTRAN 400 Series Basic Configuration Manual

3.15

Removing Settings

This section provides steps for removing settings.
3.15.1

Remove WAN Interface Setting

If for any reason you would like to return the WAN Interface setting, complete the following steps:
1. Navigate to the In the WAN Service Setup Summary screen and place a check mark in the box in the
adjacent to Interface you want removed. For this example, veip0.3 is selected.
2. Select .
Remove
Device Info
Advanced Setup
Layer2 Interface
GPON Interface
WAN Service
LAN
NAT
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 44. Remove WAN Interface Setting

3. After removing the WAN service, you need to reboot the ONT. Go to
Choose Add, or Remove to configure a WAN service over a selected interface.
Interface Description Type Vlan8021p VlanMuxId
veip0.1 ipoe_veip0 IPoE N/A N/A
veip0.2 br_veip0.1000 BRidge 3 1000
veip0.3 ipoe_veip0.100 IPoE 0 100
WAN Interface Configuration
VlanTpid Igmp Proxy Igmp Source NAT Firewall
N/A Disabled Disabled Enabled Enabled Disabled
0x8100 Disabled Enabled Disabled Enabled Disabled
0x8100 Disabled Disabled Enabled Disabled Disabled
Add Remove
"Reboot the Router"
column
Remove
IPv6 Mld Proxy Mld Source Remove Edit
Disabled Disabled
Edit
Disabled Disabled Edit
X
Disabled Disabled Edit
on page 1-73.