Set User Name And Password; Figure 41. Ppp Username And Password Screen - ADTRAN 400 Series Basic Configuration Manual

Basic Configuration
3.14.2

Set User Name and Password

If needed, a username and password can be added. Other parameters can also be entered if
desire. To create a username and password for the customer, complete the following steps:
1. In the
2. In the
3. For
4. Select
Device Info
Advanced Setup
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 41. PPP Username and Password Screen

68
PPP User Name,
used.
field, enter a password for the customer.
PPP Password
Authentication Method
If desired, other parameters can be added as needed.
.
Next
This displays the
Routing - Default Gateway
PPP Username and Password
PPP usually requires that you have a user name and password to establish your connection.
In the boxes below, enter ther user name and password that your ISP has provided to you.
Layer2 Interface
WAN Service
PPP Username:
LAN
PPP Password:
MoCA
PPPoE Service Name:
NAT
Authentication Method:
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Port Control Protocol Mode
Certificate
PCP Server
Power Management
IGMP Multicast
Multicast
Back
enter a user name for the customer. For this example, Cust 1 is
, AUTO is the default value and should not be changed.
screen (see
Cust1
*********
AUTO
Enable Fullcone NAT
Enable Firewall
Dial on demand (with idle timeout timer)
PPP IP extension
Use Static IPv4 Address
Enable PPP Debug Mode
Bridge PPPoE Frames Between WAN and Local Ports
Disable
Enable IGMP Multicast Proxy
Enable IGMP Multicast Source
Next
Figure 42 on page 69).
61287RGONT-29C
Revision C