Optional Provisioning For Pppoe; Figure 39. Wide Area Network (Wan) Service Setup Screen - ADTRAN 400 Series Basic Configuration Manual

Basic Configuration
3.14

Optional Provisioning for PPPoE

Point to Point Protocol over Ethernet (PPPoE) is a network protocol that enables data commu-
nication between two network entities or points.
Provisioning an ONT with a subtended host will enable you to get the web interface to setup
the PPPoE parameters. To provision this feature, complete the following steps:
1. Refer to
Follow the steps below to add a WAN interface for data.
2. With
3. Select
4. Select Add from the
Device Info
Advanced Setup
Layer2 Interface
WAN Service
LAN
MoCA
NAT
Security
Parental Control
Quality of Service
Routing
DNS
UPnP
FTP
SIP ALG
CloudAgent
DNS Proxy
Storage Service
Interface Grouping
IP Tunnel
Certificate
Power Management
Multicast
Wireless
DownloadFiles
Diagnostics
Management
Logout

Figure 39. Wide Area Network (WAN) Service Setup Screen

5. Select Next.
This displays the
66
"Step 2: Log On to the ONT"
GUI Interface.
Figure 9 on page 34 displayed, select Advanced Setup from the sidebar.
from the sidebar.
WAN Services
WAN Services
to set the Layer 2 interface between the CO and the customer.
WAN Service Configuration
on page 32 and log in to the ONT using the Web
menu and Figure 39
WAN Service Interface Configuration
Select a layer 2 interface for this service
veip0/veip0 v
Back
Next
screen (see Figure 40
is displayed. This menu is used
on page 67).
61287RGONT-29C
Revision C