Table of Contents
Advertisement
Connections
The SR905ac's exterior ports are shown in the following cabling diagram and explained below.
1
LAN
The four yellow RJ45 Ethernet ports located on the back of the gateway (labelled LAN1, LAN2, LAN3, LAN4) are used to connect
client devices such as computers and printers.
WAN
The red RJ45 port labeled WAN is used to connect the SR905ac gateway to another network device using a RJ45/Ethernet cable.
USB 1 & 2
Two USB ports (two 3.0 ports on back) are used to connect USB storage devices to the gateway for transferring data. They also
provide +5 VDC for charging other devices.
POWER
Use ONLY the dedicated power supply included with your gateway (3-amp 12 v). Intended for indoor use only.
l
Do NOT open the device. Opening or removing covers can expose dangerous high voltage points or other risks. ONLY qualified
l
service personnel can service the device. Please contact your vendor for further information.
External Buttons
The SR905ac gateway provides push-button controls on its exterior for critical features. These buttons provide a convenient means
to trigger WPS mode, toggle the WiFi radios on and off, or reset the gateway. The button functions are described below.
SmartRG Inc., an Adtran company. Proprietary and Confidential. All Rights Reserved. © 2020
4
WAN
LAN
USB
DC/
SFP
IN
POWER
2
3
8
- Quick Links:
- Logging in to the Sr905Ac Interface
Hide quick links:
Advertisement
Table of Contents
