Bosch EPS 708 Original Instructions Manual page 62

en 62 | EPS 708 | Maintenance
6.11 Protective plates of the protective
hood
!
The protective plates of the protective hood must
be replaced immediately if damaged (porous areas,
cracks or dents), or every 8 years due to aging (see
replacement date on protective cover).
!
Do not clean the splash guard with alcohol-based
cleaning agents, e.g. glass cleaners.
Clean the splash guard with a damp cloth (water and
detergent only) or using a plastics cleaning agent.
6.12 Cleaning the chiller
To ensure that the chiller works with optimum
efficiency and reliability, the cooling fins must be
cleaned (e.g. using a vacuum cleaner, compressed air or
soft brushes). The EPS 708 must always be switched off
before cleaning.
6.13 Replacing filter mats
Three filter mats have to be replaced. Viewed from the
front, two filter mats are located in the lower left cover
on the EPS 708 and from the rear, one filter mat is
located in the top right cover on the EPS 708.
1. Switch off EPS 708.
2. Remove the covers.
3. Remove the filter mats from the filter bags in the
covers and insert new filter mats.
4. Secure the covers.
"
The filter mats have been replaced.
|
1 689 989 067 2017-12-08
6.14 Spare and wearing parts
Designation
Monitor mount
Mouse
USB connecting cable (1,8 m)
Hoses (6x) for
<)
CRI return to valve block (1 to 6)
Drive coupling
<)
Drive coupling
<)
X24 connecting cable
<)
Adapter cable (X27 for CRI/CRI Piezo
<)
trigger electronics)
Adapter cable (X25 to high pressure rail)
<)
Inlet filters for injected fuel quantity, CRI to
<)
valve block (A to F)
Inlet filter element (6x filter, O-ring and flat
<)
sealing ring each)
Filter element with seal for test oil filter
<)
(2x)
Filter element for fine filter
<)
High pressure rail filter (2x)
<)
Volume meter filter
<)
O-rings volume meter
<)
Lubricating oil filter
<)
Filter element with O-ring for flow meter
<)
and pump return
Spare parts set (protective covers for hood)
Filter mats (4x)
<)
T-bar
Double bit key
Square box wrench
Pressure hose ID8 x 4000 mm
Hose connection
Pressure hose ID10 x 2000 mm
Hose connection
High-pressure hose assembly
Test pressure line
<) 1)
Wearing parts
<)
Included in parts set 1 687 016 064 (optional accessory).
1)
Order number
1 687 023 540
1 687 023 607
1 684 465 564
<)
1 680 712 327
to
1 680 712 332
1 686 401 024
1 686 401 026
1 684 463 946
1 684 463 698
1 684 463 744
1 687 434 067
1 687 001 974
1 687 431 026
1 687 434 072
1 687 012 144
1 687 434 051
1 687 010 136
0 451 103 139
1 687 434 073
1 687 010 356
1 687 431 023
1 683 000 000
1 681 982 010
1 681 982 011
1 687 001 851
1 683 386 130
1 680 706 047
1 683 386 131
1 680 712 324
<) 1)
1 680 750 123
Robert Bosch GmbH