Bosch EPS 708 Original Instructions Manual page 51

5.5.1 Cleaning the volume meter
Always wear protective goggles during
assembly work in the hydraulics area of the
EPS 708.
Always wear protective gloves when working
on the EPS 708.
!
Inexpert disassembly and assembly may impair
operation or the accuracy of the volume meter
(fig. 12, pos. 1).
i
Complete removal of the volume meter (EPS 708) in
order to clean the control piston or the gear pump is
not necessary.
i
Test oil escapes during disassembly of the flow
meter. Therefore, a container or cloth must be
placed under the flow meter.
958846-52_Ko
4 3
Fig. 12: Hydraulics area
1 Volume meter
2 Hose (test oil inlet)
3 Pressure-temperature sensor
4 Hose
!
Mind the mounting position of the external gear
(fig. 13, pos. 9), sickle (fig. 13, pos. 8) and internal
gear (fig. 13, pos. 10) on assembly and disassembly
of the volume meter.
Robert Bosch GmbH
1. Switch off the EPS 708.
2. Remove the front left rim (fig. 3, pos. 7).
3. Remove plastic cap (fig. 13, pos. 6) of volume meter
4. Remove (4 screws) flow sensor cap (fig. 13, pos. 7)
5. Carefully remove cylinder (fig. 13, pos. 2) with
!
6. Clean cylinder and control piston in clean test oil
7. Reinsert control piston into cylinder. Mind the
8. Check that the control piston moves easily by gently
2 1
Fig. 13:
1 O-ring
2 Cylinder
3 Control piston
4 Control piston cap
5 O-Ring
6 Plastic cover
7 Volume meter cap
8 Sickle
9 External gear
10 Internal gear
11 LED with socket
12 Driver
Testing | EPS 708 | 51
and remove LED with its socket (fig. 13, pos. 11).
and lead LED and connection cable through the flow
meter cap.
control piston (fig. 13, pos. 3). Remove control
piston.
If there are grooves on the control piston, the
volume meter must be replaced by customer
services.
and check the surfaces for scoring.
mounting position, the control piston cap (fig. 13,
pos. 4) must be positioned on the right.
moving the cylinder.
12
9
7
6
Volume meter
en
11
10
8
1
2
3
5
4
|
1 689 989 067 2017-12-08