Download Print this page

Bosch EPS 708 Original Instructions Manual page 59

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 35
6.8.2
Replacing the flow meter filter element
1
2
3
4
Fig. 24:
Flow meter filter
1 Filter element
2 O-ring
3 Union nut
4 Filter housing
1. Unscrew union nut (fig. 24, item 3) and remove it
along with filter housing (fig. 24, item 4).
2. Remove O-ring (fig. 24, item 2).
3. Detach filter element (fig. 24, item 1) clockwise and
remove it.
4. Dispose of O-ring (fig. 24, item 2) and filter element
(fig. 24, item 1).
5. Insert new filter element and tighten it
counterclockwise.
i
Make sure the sealing surfaces and the O-ring are
clean during installation.
6. Attach filter housing with new O-ring. Hand-tighten
union nut. Do not use force.
"
The filter element has been replaced.
6.8.3
Changing the pump return filter element
For filter change, see section 6.8.2.
Robert Bosch GmbH
Maintenance | EPS 708 | 59
6.9
Replacing the inlet filter cartridge
(e.g. Injector A)
i
The sediments in the inlet filters are mainly
attributable to not or insufficiently cleaned common
rail injectors before testing.
458846-24_Ko
6
5
4
Fig. 25:
Replacing the filter cartridge
1 Threaded joint
2 Flat seal
3 Spring
4 Filter cartridge
5 O-ring
6 Threaded joint
1. Detach the inlet filter from the quick-release
couplings.
2. Using two wrenches, slacken and completely
unscrew the threaded joints (fig. 25, pos. 1 and 6).
3. Take out the flat seal, spring, filter cartridge and
O-ring (fig. 25, pos. 2, 3, 4, 5).
4. Remove and dispose of the flat seal, filter cartridge
and O-ring.
5. Clean both threaded joints with clean calibrating oil.
6. Insert a new O-ring.
7. Insert a new filter cartridge, ensuring the correct
position.
8. Put on a new flat seal.
9. Insert the spring.
10. Screw the threaded joints together and tighten with
the torque wrench (tightening torque = 50 Nm).
"
The filter cartridge is now changed.
!
The inlet filters must always be inserted in the
injected fuel quantity inlets A to F (fig. 2, pos. 8)
(note the direction of flow of the inlet filters).
Never insert them in the injection chambers!
en
3
2
1
|
1 689 989 067
2017-12-08

Advertisement

loading