KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 71

Step 34: Attach Swing Assembly to Fort
A: Attach Swing Assembly from Step 5 to (2390) SW Mount with 1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock
washer, flat washer and t-nut) and 1 (G8) 5/16 x 2" Hex Bolt (with 2 flat washers and 1 lock nut) as shown in fig.
34.1 and 34.2.
B: Drive 1 (0318) Ground Stake 10-1/2" into the ground at each (1863) SW Post and attach with 2 (S3) #8 x
2-1/2" Wood Screws per ground stake. (fig. 34.1 and 34.3)
Fig. 34.1
2390
Fig. 34.2
5/16" Flat
Washer
5/16" Lock
Washer
G5
Wood Parts
2 x Ground Stake 1-1/4 x 1-1/2 x 14"
0318
5/16"
Flat
Washer
G8
1 x
G5
1 x
G8
4 x
S3
WARNING:
avoid potential injury, stakes must be
driven 10-1/2" into ground. Digging or
driving stakes can be dangerous if you
do not check first for underground wiring,
cables or gas lines.
5/16"
T- Nut
5/16"
Lock nut
Hardware
5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
5/16 x 2" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
#8 x 2-1/2" Wood Screw
71
To prevent tipping and
Fig. 34.3
1863
10-1/2"
Into Ground
S3
0318