KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 18

Step 2: Rock Wall Assembly
Fig. 2.1
0702
S2
x 4 per
board
A: Lay 2 (2555) Rock Rails down, side by side with angled edges facing down. (fig. 2.1)
B: Place (0702) CE Wall Board on the bottom of each (2555) Rock Rail as shown in fig. 2.1. Make sure (0702)
CE Wall Board is flush to the outside and bottom edges of each (2555) Rock Rail. Attach using 4 (S2) #8 x 1-1/2"
Wood Screws.
C: 8-1/4" down from the top of both (2555) Rock Rails place 1 (2257) Rock Board B, making sure the sides are
flush to the outside edges of each (2555) Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood Screws. (fig. 2.1)
D: In between the (0702) CE Wall Board and (2257) Rock Board B stagger 2 more (2257) Rock Board B's and 2
(2330) Rock Boards A's using 4 (S2) #8 x 1-1/2" Wood Screws per board. Placing them as shown in fig. 2.1, this
will prevent rocks from forming a straight line. Make sure the boards are evenly spaced and do not exceed 2-3/4"
between boards.
Fig. 2.2
PB2
Fig. 2.3
S10
Rock
Wood Parts
1 x CE Wall Board 1 x 6 x 23-1/2"
0702
3 x Rock Board B 1 x 6 x 23-1/2"
2257
2 x Rock Board A 1 x 6 x 23-1/2"
2330
2 x Rock Rail 5/4 x 4 x 54-1/2"
2555
2330
2257
Note: Gaps between
boards 2-3/4"
1/4" Lock
Washer
3/16" Flat
Washer
1/4" Barrel
Nut
Hardware
24 x #8 x 1-1/2" Wood Screw
S2
5 x #8 x 1" Pan Screw
S10
5 x 1/4 x 1-1/4 Pan Bolt
PB2
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
2330
2257
E: Place 1 rock on each rock board (fig. 2.2)
and attach using 1 (PB2) 1/4 x 1-1/4" Pan Bolt
(with lock washer, flat washer and barrel nut)
and 1 (S10) #8 x 1" Pan Screw per rock. The
Screw must be in the hole directly under the
Pan Bolt, it will stop the rock from spinning.
(fig. 2.3)
18
Note: The
holes in the
rock boards
2257
2555
must orient to
the top of the
boards.
8-1/4"
Approx
Other Parts
5 x Rocks (3 green/2 yellow)