KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 57

Step 27: Bench Assembly
Part 2
Pre-drill all holes using a 1/8" drill bit before installing the Lag Screw.
B: Attach (2491) Diagonal to (2558) Ground Back with 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer
and t-nut) and to (2383) Post with 1 (LS1) 1/4 x 1-1/2" Lag Screw (with flat washer) (fig. 27.2)
C: Drive 1 (0318) Ground Stake 10-1/2" into the ground tight to (2491) Diagonal and attach using 2 (S3) #8
x 2-1/2" Wood Screws. (fig. 27.3)
Fig. 27.2
Wood Parts
1 x Diagonal 2 x 3 x 42-1/4"
2491
1 x Ground Stake 1-1/4 x 1-1/2 x 14"
0318
2383
1/4" flat
washer
LS1
2491
2558
2 x #8 x 2-1/2" Wood Screw
S3
H2
1 x 1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1 x LS1 1/4 x 1-1/2" Lag Screw (1/4" flat washer)
WARNING:
and avoid potential injury, stakes must
be driven 10-1/2" into ground. Digging
or driving stakes can be dangerous if
you do not check first for underground
wiring, cables or gas lines.
Fig. 27.3
H2
1/4" lock
washer
1/4" flat
washer
1/4"
t-nut
Hardware
57
To prevent tipping
2491
10-1/2" Into Ground
S3
0318