KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 30

Step 12: Cafe Wall Assembly
Note: Pre-drill all holes using a 1/8" drill bit before installing the Lag Screws.
A: On the ground lay flat 2 (2383) Posts then loosely attach (0348) SL Ground with 4 (H2) 1/4 x 2" Hex Bolts
(with lock washer, flat washer and t-nut); (2371) Floor End (in the top holes) and (2387) Side Arch (in the top
holes) with 2 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and t-nut) per board, as shown in fig. 12.1.
Keep bolts loose.
B: Make sure assembly is square and then fasten (2371) Floor End to (2383) Posts with 2 (LS1) 1/4 x 1-1/2" Lag
Screws (with flat washer) and (2387) Side Arch to posts with 2 (S2) #8 x 1-1/2" Wood Screws. (fig. 12.1 and 12.2)
C: Tighten all bolts.
Fig. 12.1
H2
2383
H2
1/4" flat
washer
1/4" lock
washer
Wood Parts
1 x Side Arch 1 x 5 x 38-1/4"
2387
2 x Post 2 x 4 x 88"
2383
1 x Floor End 1 x 5 x 38-7/8"
2371
1 x SL Ground 1 x 5 x 38-1/4"
0348
2387
S2
H2
2371
H2
1/4"
t-nut
0348
H2
Hardware
8 x 1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H2
2 x 1/4 x 1-1/2" Lag Screw (1/4" flat washer)
LS1
2 x #8 x 1-1/2" Wood Screw
S2
2383
S2
Notice the hole
locations
30
Fig. 12.2
2383
2371
1/4" flat
LS1
washer