KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 32

Step 14: Swing Wall Assembly
Part 1
A: Loosely attach (2558) Ground Back using 2 (H4) 1/4 x 4" Hex Bolts (with lock washer, flat washer and t-nut)
in the top holes, (2370) Floor Back using 2 (H8) 1/4 x 4-1/4" Hex Bolts (with lock washer, flat washer and t-nut)
in the bottom holes and (2389) SW Back using 4 (H8) 1/4 x 4-1/4" Hex Bolts (with lock washer, flat washer and
t-nut) to both (2383) Posts. (fig. 14.1)
B: Loosely attach (2390) SW Mount to (2370) Floor Back and (2389) SW Back with 2 (G5) 5/16 x 4-1/2" Hex
Bolts (with lock washer, flat washer and t-nut). (fig. 14.1)
C: Make sure the assembly is square then tighten all Hex Bolts from this step.
D: Attach (2558) Ground Back to each (2383) Posts with 2 (S7) #12 x 2" Pan Screws (with flat washer). (fig.
14.1)
Fig. 14.1
2370
2383
Cafe Wall
Wood Parts
1 x SW Back 5/4 x 6 x 46-5/8"
2389
1 x SW Mount 2 x 4 x 34-1/2"
2390
1 x Floor Back 5/4 x 5 x 46-3/4"
2370
1 x Ground Back 1 x 5 x 68"
2558
2389
5/16"
t-nut
5/16" flat
washer
5/16" lock
washer
2558
with 3/16" flat
S7
washer
Hardware
G5
2 x 5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
H4
2 x 1/4 x 4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
6 x H8 1/4 x 4-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x #12 x 2" Pan Screw (with 3/16" flat washer)
S7
32
Notice holes towards top
2390
G5
1/4"
t-nut
S7
with 3/16" flat
washer
H4
2383
H8
x 4
G5
H8
x 2
1/4" flat
washer
1/4" lock
washer