KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 21

Step 5: Attach Swing End to Swing Beam
A: Place (4919) SW Rail Block in the centre between (1826) Front Beam and (1825) Back Beam and attach with
1 (H8) 1/4 x 4-1/4" Hex Bolt (with lock washer, flat washer and t-nut). (fig. 5.1 and 5.2)
Fig. 5.1
Glider Hangers must be tight
and secure to Swing Beams.
B: Attach Swing End Assembly to the side of the Swing Beam Assembly with the overhang (fig. 5.3 and 5.4) using
1 (G5) 5/16 x 4-1/2" Hex Bolt (with lock washer, flat washer and t-nut) in the top hole of Triangle Plate and 1 (G8)
5/16 x 2" Hex Bolt (with 2 flat washers and lock nut) in the bottom hole of Triangle Plate. (fig. 5.3) Make sure
Swing End Assembly flares out at an angle. (fig. 5.4)
C: Attach 2 Glider Hangers to the Swing Beam Assembly using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with 2 flat washers
and lock nut) per Glider Hanger. (fig. 5.1 and 5.3)
Fig. 5.4
Side with
overhang
Wood Parts
1 x SW Rail Block 2 x 4 x 5-3/8"
4919
Glider
Hangers
WARNING:
100°
H8
1 x 1/4 x 4-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
G5
1 x 5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
4 x 5/16 x 5-1/2" Hex Bolt (5/16" flat washer x2, 5/16" lock nut)
G7
1 x 5/16 x 2" Hex Bolt (5/16" flat washer x2, 5/16" lock nut)
G8
1826
4919
5/16" Lock
Fig. 5.3
Washer
G8
5/16" Flat
Washer
5/16"
Lock Nut
Hardware
21
H8
1/4" Lock
Washer
1/4"
T-Nut
G5
5/16"
Lock Nut
5/16" Flat
Washer
5/16"
T-Nut
Glider
Hanger
G7
2 x Glider Hanger
Fig. 5.2
1/4" Flat
Washer
1825
5/16" Flat
Washer
Other Parts