KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 33

Step 14: Swing Wall Assembly
Part 2
Note: Pre-drill all holes using a 1/8" drill bit before installing the Lag Screws.
E: Make sure the assembly is square then attach (2370) Floor Back to each (2383) Post with 2 (LS3) 1/4 x 3"
Lag Screw (with flat washer). (fig. 14.2)
F: Tight to the bottom of (2370) Floor Back and bevelled edges flush to outside edge of (2383) Posts, attach 1
(2113) Gussett II to each side using 2 (LS3) 1/4 x 3" Lag Screws (with flat washer) per gusset. (fig. 14.2)
2383
2113
Flush
Wood Parts
2 x Gusset II 5/4 x 4 x 18-1/2"
2113
Fig. 14.2
1/4" flat
washer
Hardware
6 x 1/4 x 3" Lag Screw (1/4" flat washer)
LS3
2370
2113
LS3
33
2383
LS3