KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 29

Step 11: Access Wall Assembly
Note: Pre-drill all holes using a 1/8" drill bit before installing the Lag Screws.
A: On the ground lay flat 2 (2383) Posts then loosely attach (0348) SL Ground with 4 (H2) 1/4 x 2" Hex Bolts
(with lock washer, flat washer and t-nut); and (2371) Floor End (in the top holes) with 2 (H2) 1/4 x 2" Hex Bolts
(with lock washer, flat washer and t-nut) as shown in fig. 11.1.
B: Make sure assembly is square and then fasten (2371) Floor End to (2383) Posts with 2 (LS1) 1/4 x 1-1/2" Lag
Screws (with flat washer). Tighten all bolts. (fig. 11.2)
C: Measure 28-1/4" up from the bottom of (0348) SL Ground and attach (2561) Safety Rail to each (2383) Post
with 4 (S7) #12 x 2" Pan Screws as shown in fig. 11.1.
D: Measure 8-1/2" down from the top of each (2383) Post then attach (2553) MK Board to each (2383) Post with
6 (S7) #12 x 2" Pan Screws as shown in fig. 11.1. Notice the holes are towards the bottom of the board.
Fig. 11.1
S7
x 6
1/4" flat
washer
1/4" lock
washer
H2
x 2
S7
x 4
Wood Parts
2 x Post 2 x 4 x 88"
2383
1 x SL Ground 1 x 5 x 38-1/4"
0348
1 x Floor End 1 x 5 x 38-7/8"
2371
1 x MK Board 5/4 x 6 x 38-7/8"
2553
1 x Safety Rail 5/4 x 4 x 38-7/8"
2561
2383
2553
1/4" Notice the hole
t-nut locations
2371
2561
0348
H2
6 x
H2
2 x
LS1
10 x
S7
Keep bolts loose.
8-1/2"
28-1/4"
Hardware
1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 1-1/2" Lag Screw (1/4" flat washer)
#12 x 2" Pan Screw
29
Fig. 11.2
2383
2371
LS1
1/4" flat
washer