KidKraft CRANBROOK PLAY SYSTEM Installation And Operating Instructions Manual page 43

Step 20: Upper Swing Wall Assembly
A: In between both (2383) Posts on Swing Wall side attach 7 (5265) Cedar Walls to (2370) Floor Back and
(2389) SW Back using 4 (S2) #8 x 1-1/2" Wood Screws per board. Make sure the bottom of the boards are
tight against the floor boards and the bevelled ends are at the top and facing out. Evenly space boards as
shown below. Spacing must not exceed 3" in between all boards. (fig. 20.1, 20.2 and 20.3)
Swing Wall
Fig. 20.1
2383
Wood Parts
7 x Cedar Wall 1 x 4 x 28"
5265
2389
Hardware
28 x #8 x 1-1/2" Wood Screw
S2
43
Not to
exceed 3"
5265
2383
2370
Tight
Fig. 20.2
Bevelled edges
facing out
x 4 per
S2
board
Fig. 20.3
5265 x 7