Mercedes-Benz EQC Owner's Manual page 63

60
Occupant safety
ISOFIX child seat securing system
( page 55)
/
or
i‑Size child seat securing system
( page 58)
/
O Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O Make sure that the child's feet do not come
into contact with the front seat. If neces‐
sary, move the front seat forward slightly.
®When fitting an ISOFIX child restraint sys‐
tem, also observe the following:
O When using a Group 0/0+ baby car seat
and a Group I rearward-facing child
restraint system on a rear seat: adjust
the front seat so that the seat does not
touch the child restraint system.
O When using a Group I forward-facing
child restraint system: remove the head
restraint from the respective seat, if possi‐
ble. In addition, the backrest of the child
restraint system must, as far as possible, lie
flat against the backrest of the vehicle seat.
After the child restraint system has been
removed, replace the head restraints imme‐
diately and adjust them correctly.
O For certain child restraint systems in weight
category II or III, there may be restrictions
on the maximum size setting, e.g. due to
possible contact with the roof.
O The child restraint system must not be ten‐
sioned between the roof and the seat cush‐
ion and/or be fitted facing the wrong direc‐
tion. Where possible, adjust the seat cush‐
ion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraints. Adjust
the head restraints accordingly.
° When fitting an i‑Size child restraint sys‐
tem, also observe the following:
O When using a rearward-facing child
restraint system: adjust the front seat so
that it does not touch the child restraint sys‐
tem.
O When using a forward-facing child
restraint system: remove the head
restraint from the respective seat, if possi‐
ble. In addition, the backrest of the child
restraint system must, as far as possible, lie
flat against the backrest of the vehicle seat.
After the child restraint system has been
removed, replace the head restraints imme‐
diately and adjust them correctly.