Mercedes-Benz EQC Owner's Manual page 195

192 Driving and parking
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
%
Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles
#
from a distance of 1 cm to 8 cm in front of
2 the inside rearview mirror. You should test
every position for at least 25 seconds before
trying another position.
Hold remote control
#
at various distances in front of the inside rear
view mirror. You should test every position
for at least 25 seconds before trying another
position.
Note that some remote controls transmit
#
only for a limited period, press button
remote control 5 again before transmission
ends.
Align the aerial line of the door opener unit
#
with the remote control.
% Support and additional information on pro‐
gramming:
On the HomeLink
R
466 354 65 or +49 (0) 6838 907-277.
On the Internet at http://
R
www.homelink.com.
Opening or closing the door
Requirements:
R
5 at the same angles
6 on
® Hotline on (0) 08000
#
#
The corresponding button is programmed to
operate the door.
Press and hold buttons 1, 2
the door opens or closes.
If indicator lamp 4 flashes yellow after
approximately 20 seconds: press and hold
the previously pressed button again until the
door opens or closes.
or 3 until