Mercedes-Benz EQC Owner's Manual page 177

174 Driving and parking
j Park position
k Reverse gear
i Neutral
h Drive position
Engaging reverse gear R
Depress the brake pedal and push the
#
DIRECT SELECT lever upwards past the first
point of resistance.
The transmission position display shows k
in the multifunction display.
Engaging neutral N
Depress the brake pedal and push the
#
DIRECT SELECT lever up or down to the first
point of resistance.
The transmission position display shows i
in the multifunction display.
Subsequently releasing the brake pedal will
allow you to move the vehicle freely, e.g. to push
it or tow it away.
If you want the transmission to remain in
neutral N even if the ignition is switched off:
start the vehicle.
#
depress the brake pedal and engage neutral
#
i.
release the brake pedal.
#
switch off the ignition.
#
% if you then exit the vehicle leaving the key in
the vehicle, the transmission remains in neu‐
tral i.
Engaging park position P
Observe the notes on parking the vehicle
#
( page 189).
/
Depress the brake pedal until the vehicle is
#
stationary.
When the vehicle is stationary, press button
#
j.
Park position is only engaged when the multi‐
function display j shows the transmission
position display. If no transmission position
display j appears, secure the vehicle to
prevent it from rolling away.
Park position j is engaged automatically if one
of the following conditions is met:
you switch the engine off with the transmis‐
R
sion in position h or k.
you open the driver's door when the vehicle
R
is at a standstill or when driving at a very low
speed and the transmission is in position h
or k.