Mercedes-Benz EQC Owner's Manual page 490

Blown fuses must be replaced with fuses of the
same rating, which you can recognise by the col‐
our and fuse rating. The fuse ratings and further
information to be observed can be found in the
fuse assignment diagram.
Fuse assignment diagram: on the fuse box in
the load compartment ( page 489).
/
* NOTE Damage or malfunctions caused
by moisture
Moisture may cause damage to the electrical
system or cause it to malfunction.
When the fuse box is open, make sure
#
that no moisture can enter the fuse
box.
When closing the fuse box, make sure
#
that the seal of the lid is positioned cor‐
rectly on the fuse box.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified special‐
ist workshop.
Ensure the following before replacing a fuse:
The vehicle is secured against rolling away.
R
All electrical consumers are switched off.
R
The ignition is switched off.
R
The electrical fuses are located in various fuse
boxes:
Fuse box in the engine compartment on the
R
driver's side ( page 487)
/
Fuse box on the driver's side of the cockpit
R
( page 488)
/
Fuse box in the front passenger footwell
R
( page 488)
/
Fuse box in the load compartment on the
R
right-hand side of the vehicle, when viewed
in the direction of travel (
/
Opening and closing the fuse box in the
engine compartment
Requirements:
A dry cloth and a screwdriver are available.
R
Observe the notes on electrical fuses
( page 486).
/
Opening
& WARNING Risk of injury from using the
windscreen wipers while the engine bon‐
net is open
When the engine bonnet is open, and the
windscreen wipers are set in motion, you can
be trapped by the wiper linkage.
Always switch off the windscreen wip‐
#
ers and ignition before opening the
engine bonnet.
page 489)
Breakdown assistance 487