Mercedes-Benz EQC Owner's Manual page 194

Press and hold button 1,
#
wish to program.
Indicator lamp 4 flashes yellow.
% It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp 4 continues to flash yellow.
Point remote control
#
1 cm to 8 cm towards button 1,
Press and hold button
#
5 until one of the following signals appears:
Indicator lamp
R
uously. Programming is complete.
Indicator lamp
R
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
If indicator lamp
#
green: repeat the procedure.
Release all of the buttons.
#
% The remote control for the door drive is not
included in the scope of delivery of the
2 or 3 that you
garage door opener.
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
5 from a distance of
2 or 3.
6 of remote control
4 lights up green contin‐
4 flashes green. Pro‐
4 does not light up or flash
Driving and parking 191
The vehicle as well as persons and objects,
R
are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.