Mercedes-Benz EQC Owner's Manual page 181

178 Driving and parking
Function of the charge level display in the
multifunction display
1
Current charge level
2
Time at which completely charged
When the vehicle is connected to the mains sup‐
ply and the ignition is switched off, the multi‐
function display shows the charge level display
for approximately two minutes.
% The values displayed vary depending on the
setting of the charging process. The set
departure time may also be displayed, for
example.
Configuring the charging time settings
Multimedia system:
© Settings EQ
4 5 5
Setting the charging process
Select Departure time.
#
The following charging times can be selected:
Charge immediately (no departure time)
R
Once (00:00)
R
Week profile
R
Select a setting.
#
Setting a single departure time
Select Departure time.
#
Select Edit single time.
#
Set a departure time.
#
Setting the week profile
Select Departure time.
#
Select Edit week profile.
#
Set the desired departure times, e.g. every
#
day at 8:00 a.m.
Setting the maximum charging current
Select Maximum charge current.
#
Select Maximum, 8 amps or
#
When the high-voltage battery is charged, the
charging current is limited to the selected
amperage.
% The value of the maximum charging current
depends on the fixed value charging cable
which was provided.
Setting the maximum charge level
Select Maximum charge state.
#
Set the desired percentage.
#
The high-voltage battery is charged up to the
set percentage as a maximum.
% The percentage can be set in increments of
10%.
A maximum charge level of 80% is recom‐
mended. Higher maximum charge levels can
diminish the longevity of the high-voltage
battery ( page 175).
/
6 amps.