Mercedes-Benz EQC Owner's Manual page 506

The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shift the transmission to position j.
#
Switch off the drive system.
#
Make sure that the drive system cannot be
#
started.
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
Raise the vehicle ( page 503).
/
#
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change ( page 502).
/
Important notes on using the jack:
Use only a vehicle-specific jack that has
R
been approved by Mercedes-Benz to raise
the vehicle.
The jack is only designed for raising and
R
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
The foot of the jack must be positioned verti‐
R
cally under the jack support point.
Wheels and tyres 503
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the
R
vehicle.
Never lie under the vehicle.
R
Do not start the drive system and do not
R
release the electric parking brake.
Do not open or close any doors or the tail‐
R
gate.
Using the wheel wrench, loosen the wheel
#
bolts on the wheel you wish to change by
about one full turn. Do not unscrew the bolts
completely.