Diagnostics Connection; Qualified Specialist Workshop - Mercedes-Benz EQC Owner's Manual

Authorised representative: IMS dept.
Date: June 2015
Signature: IMS-AM, IMS-AE-L

Diagnostics connection

The diagnostics connection is only intended for
the connection of diagnostic devices at a quali‐
fied specialist workshop.
& WARNING Risk of accident due to con‐
necting devices to the diagnostics con‐
nection
If you connect equipment to a diagnostics
connection in the vehicle, it may affect the
operation of vehicle systems.
As a result, the operating safety of the vehi‐
cle could be affected.
Only connect equipment to a diagnos‐
#
tics connection in the vehicle which is
approved for your vehicle by Mercedes-
Benz.
& WARNING Risk of accident due to
objects in the driver's footwell
Objects in the driver's footwell may impede
pedal travel or block a depressed pedal.
This jeopardises the operating and road
safety of the vehicle.
Stow all objects in the vehicle securely
#
so that they cannot get into the driver's
footwell.
Always fit the floor mats securely and
#
as prescribed in order to ensure that
there is always sufficient room for the
pedals.
Do not use loose floor mats and do not
#
place floor mats on top of one another.
* NOTE Battery discharging from using
devices connected to the diagnostics
connection
Using devices at the diagnostics connection
drains the battery.
Check the charge level of the battery.
#
General notes
If the charge level is low, charge the
#
battery.

Qualified specialist workshop

A qualified specialist workshop has the neces‐
sary special skills, tools and qualifications to
correctly carry out any necessary work on your
vehicle. This particularly applies to safety-rele‐
vant works.
Always have the following work carried out on
your vehicle at a qualified specialist workshop:
safety-relevant works
R
service and maintenance work
R
repair work
R
modifications as well as installations and
R
conversions
work on electronic components
R
Mercedes‑Benz recommends a Mercedes‑Benz
service centre.
25