Cable Connections; Usb Interface - GCC Technologies Puma III Series User Manual

Hide thumbs Also See for Puma III Series:

Table of Contents

Puma III User Manual

2.4

Cable Connections

Puma III communicates with a computer through USB (Universal Serial Bus),

Parallel port (Centronics) or Serial port (RS-232C). This chapter shows you

how to connect the cutting plotter to a host computer and how to set up the

computer/cutting plotter interconnection.

Notice:

When USB connection is enabled, both parallel port and serial port will

be disabled automatically.

Parallel port

USB port

Serial port

Figure 2-18

Puma III build-in USB interface is based on the Universal Serial Bus

Specifications Revision 1.1. USB is not available in Windows 95, Windows NT.

USB driver installation

Caution!! Don't plug USB cable into plotter before you install USB driver.

a. Put USB cable aside (don't plug it into Puma III).

b. Insert "Installation CD", and then click on "USB driver" to install USB driver.

USB driver will remove drivers which occupy USB port first, then install GCC

USB driver. The USB driver was installed successful when a popup window

shows "USB Driver installed".

Installation

2-9

Table of Contents