Operation; Display Of The Monitoring Status; Display During Normal Operation - Pilz PSEN sc M 3.0 08-12 Operating Manual

Operation

10 Operation
10.1

Display of the monitoring status

Icon
Valid config- Configura-
uration tion not yet
accepted
10.2

Display during normal operation

Message in the display
Icon Text
CLEANW2
DLDNC
Operating Manual PSEN sc M 3.0/5.5 08-12
1005055-EN-03
Status
Device is switched on and ready for
operation
Warning zone has been violated
Safety zone has been violated
Change detected in the reference
outline
Status
The front panel must be cleaned
Download of a configuration or a re-
port
Description/measure
A violation of the warning zone has
been detected. The configured ac-
tion for a violation of the warning
zone has been triggered.
The area of violation is marked out-
side the semicircle with the yellow
beams.
A violation of the safety zone has
been detected. The OSSDs are in
the OFF state.
The area of violation is marked out-
side the semicircle with the red
beams.
A violation of the reference outline
has been detected. The area of
change is marked outside the semi-
circle with the blue beams.
Check the cause for the change and
eliminate the cause or adapt the ref-
erence outline.
Description/measure
Decommission the safety laser
scanner.
Clean the safety laser scanner's
front panel [ 97].
A configuration or a report is
downloaded.
| 87