Monitoring Of Reference Outlines - Pilz PSEN sc M 3.0 08-12 Operating Manual

Project configuration
Fig.: Example for the automatic coding of 6 zone sets by the PSENscan Configurator to ensure the
differentiation to the next monitoring case (Hamming code)
5.4

Monitoring of reference outlines

An outline within the area covered by laser beams can be defined and monitored in
PSENscan Configurator as a reference outline.
The outline must be outside the protective zone and it consists of at least 3 and a max. of
15 reference points.
When PSEN sc M 3.0/5.5 08-12 series detects a change of the outline, the safety laser
scanner switches the OSSDs to the OFF state. A change in the area of a tolerance that can
be set in PSENscan Configurator is accepted.
For vertical applications, national and international standards recommend monitoring a ref-
erence outline.
The reference outline is configured during the first installation of PSEN sc M 3.0/5.5 08-12
series. The distances measured during configuration are used as reference values for mon-
itoring the reference outline.
Monitoring of reference outlines is used to detect any changes or changes to the environ-
ment of the safety laser scanner.
}
Changes to the installation position of the safety laser scanner due to vibration
} Changes of the safety laser scanner due to manipulation
}
Changes of an additional protective equipment
Operating Manual PSEN sc M 3.0/5.5 08-12
1005055-EN-03
| 35