Diagnostics; Led Signaling; Figure 20: Leds Indicating Operational Messages (Exemplary); Table 30: Operating Messages 1 - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-4804/000-800 8DO 24V DC 2.0A IF (4xM12)
Pos : 40 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Diag nos e/Di agnos e - Ü bersc hrift 1 @ 4\mod_1240831069471_21.doc x @ 31372 @ 1 @ 1
9

Diagnostics

Pos : 41 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Diag nos e/LED-Signalisierung - Ü bers chrift 2 @ 4\mod_1240831118032_21.doc x @ 31375 @ 2 @ 1
9.1

LED Signaling

Pos : 42.1 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen Einl eitung @ 7\mod_1268130796113_21.doc x @ 52028 @ @ 1
The following table lists the operating messages that are indicated via LEDs.
Information regarding remedies of certain causes is also provided.
Pos : 42.2 /Serie 767 (WAGO-SPEED WAY)/Wic htige Erläuterungen/Sicherheits hinweis e/Hi nweis /Hinweis: 767- 4xxx/- 5xxx Betriebs meldungen Deakti vierbar e Diag nos en @ 7\mod_1265892089421_21.doc x @ 50332 @ @ 1
Disabling specific diagnostics
Use the diagnostic overview (section "Parameterizing" > "Diagnostic Overview")
to disable specific diagnostics (see F- and I/O-LED). In this case, the
corresponding LED is disabled (off).
15
Pos : 42.3 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx Abbildung 4xM 12 @ 5\mod_1249454812578_21.doc x @ 40396 @ @ 1
17
19

Figure 20: LEDs indicating operational messages (exemplary)

Pos : 42.4 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx Allgemei n (Pos.15, T eil 1) @ 5\mod_1249461825765_21.doc x @ 40406 @ @ 1

Table 30: Operating messages 1

Pos. LED Color/Status
15 SB
Manual
Version 1.1.0
16
17
18
Off
Red, flashing,
4 Hz
Red, flashing,
1 or 2 Hz
Green
Cause
Low voltage;
U not available.
LS
S-BUS error on module.
The module is being restarted
via the fieldbus coupler.
Data exchange is in process;
process data values are valid.
The module is in RUN mode.
Diagnostics
Remedy/information
Check the power supply.
Check whether the S-BUS
cable is connected.
Check the S-BUS cable for
damages.
Check whether the fieldbus
coupler firmware is
compatible with the module.
If the flashing frequency is
1Hz, please contact WAGO
Support.
-
63