Table 31: Operating Messages 2 - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-4804/000-800 8DO 24V DC 2.0A IF (4xM12)
Pos : 42.7 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- 48xx F, I/O (Pos. 16 + 17) @ 5\mod_1249463167562_21.doc x @ 40410 @ @ 1

Table 31: Operating messages 2

Pos. LED Color/Status
16 F
17 I/O
Pos : 42.8 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx U LS und UA (Pos. 18 + 19) @ 8\mod_1278577022948_21.doc x @ 59316 @ @ 1
18 U
A
19 U
LS
Pos : 43 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Cause
Red There is at least one global
diagnostic message on the
module.
Yellow Output signal pending.
Red* Error on output.
* If you set the time of the parameter "Restart delay, actuator" (section
"Parameterizing" > "Parameters of outputs") to 0 ms, the I/O LED appears yellow
rather than red in case of a short circuit or overload due to the short restart
interval.
Green Actuator supply U
present.
Off Actuator supply U
present.
Green Logic supply and sensor
supply U
Off Logic supply and sensor
supply U
Remedy/information
Check the supply voltages U
and U
Series components. For more
information, see the section
"Parameterizung" >
"Diagnostic Overview".
-
Inspect the actuator
connection for short
circuit/overload or line break.
If the output is switched on,
any short circuit or overload
that occurs can be diagnosed,
an interruption cannot. If the
output is switched off, only an
interruption detection can be
diagnosed (line break).
is -
A
is not Connect the power supply and
A
check the voltage level, if
applicable.
-
are present.
LS
Connect the power supply and
are not present. check the voltage level, if
LS
applicable.
Diagnostics 65
LS
of the upstream 767
A