Data Transfer Via Lan - AJA Ki Pro Ultra 12G Installation And Operation Manual

There can be only one Master in a gang; typically, the IP address for the
Ki Pro Ultra 12G unit you entered and are viewing the web UI on is the one which
should be promoted to the controlling role. If the unit with the IP address that is
currently being viewed via the web UI is selected, a red capitalized MASTER text
will appear on the web page above the columns.
A Master Ki Pro Ultra 12G unit can send three items to the subordinate
Ki Pro Ultra 12G units within a gang; a record start command, a stop command,
and clip naming.
The Settings area is where the Ki Pro Ultra 12G clip name for each unit is decided.
By default, Ki Pro Ultra 12G is configured to use the standard clip naming
conventions, not the custom clip naming conventions. The first user selection is
Use Custom Clip Name; if you want to use the standard clip naming convention,
leave this set to OFF, but if you want to create a custom clip name, mouse click
on the OFF to reveal a pulldown for OFF/ON selection then click OK. If OFF was
selected, the next parameter would be Clip Name, again, clicking on the SC or
Clip presented brings up the pulldown and the OK box. Clip Number must be
entered manually with a valid value for Ki Pro Ultra 12G of 1 through 999 and then
the enter/return key must be hit. If the enter/return key is not entered after the
selection, the value will revert to whatever was previously shown.
Clicking on the value next to Clip Append and Alpha Append both bring up a
pulldown and an OK button. Take operates like the Clip Number, where a valid
value of 1 to 999 can be entered and the enter/return key needs to be hit for
confirmation of the value. For custom clip naming considerations, see
Clip Naming" on page
Note that for Subordinate Ki Pro Ultra 12G units, the Settings column provides
a selection of either Use: Master Name or Subordinate Name. Clicking on the
default value of Master Name pulls up a pulldown selection of Master Name
or Subordinate Name with an OK confirmation button. If the desire is to have
clips named the same across all Ki Pro Ultra 12G units' recordings, then select
Use: Master Name. If the desire is to have clips named independently on
Ki Pro Ultra 12G units, then select Subordinate Name. Selecting Subordinate
Name means that the recording will take it's name from the individual
Ki Pro Ultra 12G's parameters and not accept the value pushed to the Subordinate
by the Master Ki Pro Ultra 12G.
NOTE: Ki Pro Ultra 12G can initiate recordings among units quickly, but not all units will
NOTE: Ki Pro Ultra 12G does not provide simultaneous playback of media; only record

Data Transfer via LAN

There are two ways to access Data Transfer mode:
• Use the Ki Pro Ultra 12G front panel UI to set Media State to Data-LAN (see
Figure 21 on page 73
• Access the Playlist web page and the All Clips mode then click on the media
state toggle icon.
Appropriately encoded files may be uploaded to the Ki Pro Ultra 12G or
downloaded from the Ki Pro Ultra 12G.
Ki Pro Ultra 12G File Based Recorder/Player v1.0
42.
begin or end recordings precisely at the same time or the same frame. This is not
an issue if matching timecode via LTC or RP188.
start and stop functions are available.
and "12.1 Media State" on page 35).
72
"Custom
www.aja.com